Logic Pro X Reset Control Surfaces and V-Control

Logic Pro X Reset Control Surfaces and V-Control

If Logic is not connecting to Raven and the Transport and Faders are not functioning, then there is likely a problem with V-Control and Logic communication. To reset the Logic Control Surfaces go to Logic Pro X->Controller Surface-Setup.

Screen_Shot_2021-09-06_at_8.41.11_AM.png

Select all the Controllers and then hit "Delete" from the edit drop menu.

Screen_Shot_2021-09-06_at_8.42.59_AM.png

Re-Launch Logic Pro X and select "Add" when the V-control message pops up..

logic_automatic_install.png

Double check "V-Control Setups" tab to see that Logic and Raven are being seen by V-Control..

Screen_Shot_2021-09-06_at_8.42.33_AM.png

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.